Our Services:
Concrete Wall Sawing

Concrete Wall Sawing that is powered by air, electric, and hydraulics is an art that requires special attention. We use this saw to cut concrete doors, window, and other objects that most other saws just can't cut. It is one of the most involved processes we have, and we make it simple for those who need it done. Most of our customers require a door or window cut. This process involves water and some noise that is mostly done outside. Usually a tarp will be placed on the inside to stop spray or misting from the saw blade when it cuts though the concrete. Whether you need it done from the inside or outside of the building or home we will discuss the whole procedure before hand.

  • concrete wall sawing - concrete cutting contractor - south shore massachusetts Concrete wall 10 inches thick cut for new window installation
  • concrete wall sawing - concrete cutting contractor - south shore MA Concrete wall removed from opening for new window installation
  • concrete wall sawing - concrete cutting contractor - south shore massachusetts New window installed after concrete cutting was completed and debris removed from site
  • concrete wall sawing - concrete cutting contractor - south shore massachusetts Take a look at your new view from your once closed-in basement, Priceless!

Requirements for Concrete Wall Sawing for cutting concrete wall:

  • Layout must be done by customer or general contractor. All cuts should be marked before Cape Cod Concrete Cutting arrives on site.
  • Access is very important because our equipment is very heavy, and lines are run to power this piece of equipment. So please allow us to get as close to the work as possible.
  • If you need a doorway or window in your basement you must clear the area that needs to be cut. The area must be cleared away from the opening in a 5 foot radius. This must be done because of water spraying in from outside.
  • The minimum hole requirements for cutting an opening from outside are 18 inches from the sides, 4 feet back from the structure, and 1 foot deeper from the bottom cut. If you need to bury the piece dig deep enough to allow it to drop at the correct depth.
  • Please make sure there is nothing in the area like electrical wiring, gas pipe, or anything that could be damaged and hinder the cutting process. If there is, please have it moved by a professional before we arrive to the site.
  • Flush cutting an opening with blade cutting directly on top of concrete floor is performed, but is a special request.
  • Water is an issue, so please let us know if water control and plastic tarps will be necessary at your residence or commercial project.
  • If water and power is not present we can provide it.
  • These are typical requirements and may not pertain to every job.